Low Rise Lifts - Rotary XLP25

Although particularly suited to tyre shops and bodyshops, the Rotary XLP25 can also safely improve vehicle access in service bays where low ceiling height may be a problem. A useful 2.5 tonne capacity combined with variable platform length, an unusually low loading height and a degree of mobility, make this lift particularly versatile.

Wheel Support Scissor Lifts - Rotary M & MLP Series

The modern, space saving alternative to the traditional 4 post lift. Ideal for routine service work or specialist applications such as wheel alignment.

M Series - In-ground Models

When installed, these high specification lifts are ideal for use with low skirt vehicles or in workshops where wheel support lifts are needed but a completely level floor may also be required. All models have a 4.5 tonne capacity, a lifting stroke of 1.8m, an overall width of 2.3m, and a rise and lowering time of 45 seconds. Each lift is fitted with an advanced, fail safe, air operated safety locking system. There is an option of 4.2 or 4.8m long platforms within the range.

MLP Series - Surface Mounted Models

A range of very stable, surface mounted scissor lifts for use where space may be limited, wheel support is required and an inground installation is not possible. Loading height is particularly low at 125mm. Capacities range from 3 to 5 tonnes and platform lengths from 4.4m to 4.8m.The lifting stroke, at 1950mm, and the rise time of 50 seconds is common to all versions.There are two platform configurations - plain or a wheel alignment version featuring 50mm deep front turn plate recesses as well as rear slip plates. Some models require air.

Sill Support Scissor Lifts - Rotary G & GLP Series

Designed to allow you to get the most out of your workshop, the sill type scissor lift is the natural, space saving alternative to the two post lift. The Rotary G & GLP models are modern, sophisticated, hydraulically operated products with lifting capabilities ranging up to 4 tonnes capacity. Their short, extendable platforms make driving on quick and easy whilst permitting full length unobstructed access to the underside of the vehicle.Their low-profile design means that they can be recessed into the floor with minimum civil work, or surface mounted with a very low closed height.

Product Range

XLP25
2500kg Capacity

GLP30
3000kg Capacity

M40N-42/48
4000kg Capacity

M40NAT-42/48
4000kg Capacity

M40LT-42/48
4000kg Capacity

M40LTAT-42/48
4000kg Capacity

M50N-46/52
5000kg Capacity

M50NAT-46/52
5000kg Capacity

M50LT-46/52
5000kg Capacity

M50LTAT-46/52
5000kg Capacity